Aeromix Stereo Mic/Line Mixer


AEROMIX AMX123 Mic/Line Mixer

Here's a simple strip mixer with less knobs than our evergreen Aeromix 2+2. It offers more options to the installer to get a better sound from the system.

Let's take a look at the features on the front from left to right and then the options we've built in to the back panel. VOICE - There is only one volume control but you can connect two wireless mic systems into the 2 Mic In sockets on the rear panel. You mix them together through the one channel. On the back we've added a MIC INSERT Socket. This lets you send the mic signal for processing to an outboard Graphic Equaliser and return it back to the Voice Channel at Line Level. Neat! Next to it is a MIC TRIM screw pot that will give you more or less mic volume if it's needed. There's also a low cut filter called MIC FILTER to reduce the bass frequencies of male voices. Use with systems that have big bass drivers or sub-woofers to remove room boom sounds from the mic signal. 

MUSIC 1It has the standard 2 RCA sockets to connect a CD Player, iPod® Dock or our Aerolink Bluetooth Receiver. Use the Bass and Treble controls for the right amount of cut or boost of the music you are playing. Then you can remove the knobs and replace them with two black blanking plugs provided with the mixer! Very cool!  MUSIC 2. Use with MP3 Players, smartphones, computers and tablets. In fact, any playback device where the sound comes out of a headphone socket. Connect a 2 x RCA plug to 3.5mm stereo jack into the back. The sound comes out with plenty of gain to match the output of a CD player. The PUNCH button is there to add a pre-set Bass & Treble lift to the music. It's really good at low volumes and awesome when played louder. 
USB POWER. There are two USB power sockets provided on the AMX123 Mixer. They will trickle charge phones while in use.  Please note: these are battery charging sockets only - they will not play a USB thumbdrive. 
MASTER VOLUME. The screwdriver adjustable Master Volume is in the middle of the rear panel. It's a signature feature of our mixers! The main Voice over Music balance can be set on installation day then left alone.  AUDIO SLAP. Connect a 2 wire cable to our LM-30 Loudness Monitor from the 3 pin green Euroconnector and the Music input signal will be cut by 15dB until it's turned down. Together they manage the volume levels when the management is away.
OUTPUTS. There are 4 x 6.35mm TRS electronically balanced output sockets for connecting to Power Amplifiers. There's the standard LEFT and RIGHT outputs to use with Stereo Systems. There's a MONO Output for use in wide rooms or to feed sub-woofers or to run the sound through a 100V line system. Then there's a MOM output! Music Only Monitor is a feed without vocals. Use it to run a powered foldback speaker when using omni microphones like the Aeromic.
There is so much more to this mixer than you can see from just looking at the front panel - give it a go!

You recently viewed

Clear recently viewed